Crystalline Waterproofing Slurry

 CRYTALLINE WATERPROOFING SLURRY

1. Description:

- Cementitious, capillary active waterproofing slurry for the secure waterproofing of concrete substrates also against negative water pressure.

- External and internal waterproofing in cellars, lift pits, foundations, pile foundations, floor slabs etc.

- Waterproofing of containers for potable and service water, retaining tanks, water treatment plants and similar.

- Waterproofing beneath screeds (unbonded or floating screeds).

- Approved for potable water structures according to DVGW

2. Usage:

• Waterproofing inside and outside of tunnels, lift cores, foundations, retaining walls.

• Waterproofing of drinking water tanks and services, water tanks, water treatment plants, garages, tunnels.

• Waterproofing under screeds (non-bonding or underlaying mortars).

• Need to analyze water when hardness ≤ 3 ° dH. AQUAFIN-IC is resistant to strong chemical attacks (anti-XA2 level according to DIN 4030)

3. Specifications:

- Basic ingredients: sand / cement, additives

- Color: gray

- Density density: 1.1 kg / l

- Blending level: 25 kg AQUAFIN-IC with ن .75 to 8.0 l of clean water

- Mixing time: 3 minutes (stirring 500 - 700 rpm)

- Time to allow 30 to 60 minutes of application (at + 23 ° C / 60%)

- Construction temperature / material: Minimum + 5 ° C, maximum + 35 ° C.

- Prolonged low temperature, high temperature shorten maintenance time

- Packing: 25kg bag

- Cleaning tools: With water in fresh condition, remove dry materials with ASO- Steinreiniger

- Storage time: 12 months if stored dry, no freezing in original bag

- Use immediately after opening the bag.

4. Compressive strength:

  + About 18 N / mm2 after 7 days

  + About 21 N / mm2 after 14 days

  + About 25 N / mm2 after 28 days

- Flexural strength: about 6 N / mm2 after 28 days (ASTM C 580: 96)

- Adhesion strength: about 1 N / mm2 (ASTM D 4541: 2002)

- Water resistance: Minimum of 13 bars on the opposite or opposite side (CRD-C 48-92, US)

5. Material consumption:

- Dry film thickness: Minimum 0.8 mm -1.5 mm

- Wet soil / non-static drainage 0.75 kg / m2 of mulch

- Non-hydrostatic pressure: 1.2 kg / m2 of two coats

- Pressure water / rising water: 1.5 kg / m2 of two coats

* Consumption may increase for non-flat surfaces

- Ready to exposed environment + 20 ° C and relative humidity for 60%:

  + Rain resistant after about 24 hours
 

  + Bear walking after about 5 hours
 

  + Backfill the building after about 3 days
 

  + Fill the container after about 7 days

If you have any inquiries, please contact us through our hotline or send us an e-mail. We are honored to serve you!