×
|
Service:
|
Air and non-combustible, compatible gases. (Natural Gas option available.)
|
|
Note:
|
May be used with hydrogen. Order a Buna-N diaphragm. Pressures must be less than 35 psi.
|
|
Wetted Materials:
|
Consult factory.
|
|
Housing:
|
Die cast aluminum case and bezel, with acrylic cover, Exterior finish is coated gray to withstand 168 hour salt spray corrosion test.
|
|
Accuracy:
|
±2% of FS (±3% on -0, -100PA, -125PA, -10MM and ±4% on -00, -60PA, -6MM ranges), throughout range at 70°F (21.1°C).
|
|
Pressure Limits:
|
-20 in Hg. to 15 psig.† (-0.677 bar to 1.034 bar) MP option 35 psig (2.41 bar), HP option 80 psig (5.52 bar).
|
|
Overpressure:
|
Relief plug opens at approximately 25 psig (1.72 bar), standard gages only. See Overpressure Protection note on Catalog page.
|
|
Temperature Limits:
|
20 to 140°F (-6.67 to 60°C). -20°F (-28°C) with low temperature option.
|
|
Size:
|
4″ (101.6 mm) diameter dial face.
|
|
Mounting Orientation:
|
Diaphragm in vertical position. Consult factory for other position orientations.
|
|
Process Connections:
|
1/8″ female NPT duplicate high and low pressure taps – one pair side and one pair back.
|
|
Weight:
|
1 lb 2 oz (510 g) MP & HP 2 lb 2 oz (963 g).
|
|
Standard Accessories:
|
Two 1/8″ NPT plugs for duplicate pressure taps, two 1/8″ pipe thread to rubber tubing adapters and three flush mounting adapterswith screws. (Mounting and snap ring retainer substituted for three adapters in MP & HP gage accessories.)
|
|
Agency Approvals:
|
Meets the technical requirements of EU Directive 2011/65/EU (RoHS II). Note: -SP models not RoHS approved. Note: For applications with high cycle rate within gage total pressure rating, next higher rating is recommended. See Options Page.
|
Should you need any further information, please do not hesitate to contact us!
Create a free Listing to introduce your business and be visible to your potential customers
_________________________________
YELLOW PAGES CONTACT
+84 24.3636.9512 (Ext 312)
Hotline/ Zalo: +84 914 261 828 (Ms Amy)
